Herculanfloor®- 313 waterborne epoxy surface coating

High brightness, water solubility, low VOC content,

Green & nbsp; Good physical properties (excellent wear resistance and scratch resistance)

The coating is smooth, full and semi dull & nbsp; Tough paint film,

Excellent scratch resistance, washing and impact resistance & nbsp; Oil stain resistance

Solvent and other chemical media can effectively protect the concrete floor;

Meet the requirements of GB / T 22374-2018

Component A: 16KG component B: 4kg

The shelf life of the material is 24 months under the condition that the original packaging bag is sealed, dry, stored without direct sunlight and the temperature is 5 ℃ - 35 ℃. Avoid freezing.

Volatile organic compound content VOC: 22

State in the container: stir and mix evenly without hard blocks

Drying time (surface drying): ≤ eight

Drying time (dry): & le; forty-eight

Sum of benzene, toluene, ethylbenzene and xylene, mg / kg: not detected

Wear resistance (750g / 500r): 0.046

Free formaldehyde, mg / kg: not detected

Soluble heavy metals (color limiting paint) lead, cadmium, chromium and mercury, mg / kg: not detected

Gloss: bright

Substrate requirements: the coating surface of architectural coating must be dry, firm, clean and flat;

Construction environment: the ground temperature shall not be lower than 5 ℃, and the ambient humidity shall be lower than 85% to ensure good film formation;

Please strictly abide by the construction time limit parameters!

Diluent can be added appropriately according to different construction methods and construction environment, but the dilution ratio shall be strictly controlled. Excessive diluent is strictly prohibited. The main agent and curing agent must be mixed in the correct proportion. The main agent shall be mixed with an electric mixer first, and then slowly add curing agent to fully mix evenly;

The compressive strength of base course must be greater than 30n / mm2.

Correct base treatment is conducive to obtain ideal performance.

The substrate surface must be firm, clean and free from loose particles, oil, esters, or other impurities. Use industrial cleaners to remove oil, grease, wax, etc., or use mechanical cleaning methods to remove grease. Sand blasting can be used for cement mortar, loose particles, release agent, curing agent and other impurities, and the bonding strength of the base course after surface treatment shall be at least 1.5n/mm2 (tensile test method can be used to test at the speed of 100N / s).

Surface defects such as holes and cracks in the base course can be repaired with epoxy mortar series to obtain a smooth and flat surface. To prevent the wall and column from being splashed by epoxy products during construction, polyurethane protective plate and protective layer shall be used;

Herculanfloor®- 313 water based epoxy surface coating dosage: 0.3kg/m2

For complete information on health and safety, please refer to the corresponding material safety data manual. Keep away from children; Keep the product container closed when not in use: generally, when using and storing chemical products, pay attention to avoid opening eyes, mouth, skin and food; Use in a well ventilated environment and avoid inhalation; If necessary, use appropriate respiratory equipment: wear protective glasses and gloves when using:. No smoking during use and storage: if in eyes, rinse thoroughly with water for at least 15 minutes; In case of contact with skin, wash the contacted part with soap and water;

In order to obtain information and suggestions on the safe operation, storage and handling of chemicals, users should refer to the latest material safety manual containing physics, biology, toxicology and other relevant safety data.

Due to different specifications for the performance of the product in different countries, please consult the local product technical data for the specific construction field description of the product.